Skip to main content

Correct installation of the socket

To ensure your LED turn signal clicks in to its socket correctly, it is very important to ensure installation of the socket nut is installed correctly.

Use the supplied nylon washer/spacers to ensure the lower surface of the locking nut’s notch ends up flush with the thread of the socket. Without this alignment the light will not fully engage with the retaining spring and may cause the light to fall out during your ride. If there is not enough thread showing, use hi grit sandpaper, dremmel tool or similar to reduce the thickness of plastic on your bike, working from the inside of the plastic to achieve the desired thread length.

Finally, align the notch so that it is aligned horizontally and that the dust plug can be secured into the back of the light when clicked in. Apply a small amount of Loctite (Low – purple 222 or Medium – blue 243) to the thread and you’re done.